Hi all, I am running a 2 MSE, 4 Controller setup, all managed by the WCS server. I am trying to configure the wIPS profile. I am able to create the profiles and when I go to apply it to the MSEs I get an error message. Each MSE has two controllers assigned to it. My question is is there something wrong with the setup? Should I send all controllers to one MSE and leave the other as a back up, or can I load balance between the two? If I can then how come WCS is not allowing me to assign a profile to both MSEs.
Transferring Crash file from standby: Login to the Active WLC in HA.
From CLI: (Cisco Controller) >transfer upload datatype crash (Cisco
Controller) >transfer upload filename (Cisco
Controller) >transfer upload mode tftp (Cisco Controller) >transfer
This is the start of a display filter cross reference between Wireshark
and OmniPeek. The 1st installment is a table of advanced filters. More
filters will be added as time allows. It is a living doc, so check back
for changes every so often Please feel f...