Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

Configuring WPA2 in CISCO AIRONET AP

I'm tconfiguring a new Aironet 1142 wireless access point with the web
configuration utility. I only need a simple single SSID, no VLANs, and a
WPA2 autentication password (I can't let it with a 128 bits wep password
because the ap is for normal random users). The thing is that when im
configuring the wpa it ask me for a radius server... and I just need a
simple access point. If you guys can help me with the cli or web configuration
 I'll be grateful

Everyone's tags (1)
11 REPLIES
Silver

Do check this guide its a

Do check this guide its a basic config guide as required

http://www.cisco.com/c/en/us/td/docs/wireless/access_point/1140/autonomous/getting_started/guide/ap1140aut_getstart.html

 

***********Do rate helpful links************************

Community Member

I already have configured

I already have configured those parameters, but what I need is a simple WPA password authentication, and those options always take me to the radius configuration somehow... can be done? what I want? configure wpa like a normal AP?

 

Silver

you need to configure static

you need to configure static WEP with static key

http://networking-newbie.blogspot.com/2008/11/configuring-wpa-and-wpa2-on-cisco.html

or

check this link for command line configuration

http://networking-newbie.blogspot.com/2008/11/configuring-wpa-and-wpa2-on-cisco.html

Note:

donot select this it mean different here

WPA—Wi-Fi Protected Access (WPA) permits wireless access to users authenticated against a database through the services of an authentication server and encrypts their IP traffic with stronger algorithms than those used in WEP. As with EAP authentication, you must enter the IP address and shared secret for an authentication server on your network (server authentication port 1645).

Hi,What type of security do

Hi,

What type of security do you want to use?

PSK (preshared key,just a static password) or 8021.X authentication?

 

Regards

Bronze

Hi, Configure your AP as

Hi, 

Configure your AP as autonomous AP and then select the security mode WPA-Personal instead of WPA-Enterprise.

 

Bronze

http://www.cisco.com/c/en/us

http://www.cisco.com/c/en/us/td/docs/wireless/access_point/15-3-3/configuration/guide/cg15-3-3/cg15-3-3-chap10-cipherwep.html

Community Member

Hi guys, I apologize for my

Hi guys, I apologize for my late response, I figured out how to configure the AP, I will share the configuration when I get home.

Cisco Employee

Refer the link : http://www

Community Member

Hi guys, I apologize for my

Hi guys, I apologize for my late response, I figured out how to configure the AP, I will share the configuration when I get home.

Refer the autonomous confg.

Refer the autonomous confg. from

http://www.cisco.com/c/en/us/td/docs/wireless/access_point/1140/autonomous/getting_started/guide/ap1140aut_getstart.html#wp33244

 

Community Member

Hi guys, I apologize for my

Hi guys, I apologize for my late response, I figured out how to configure the AP, I will share the configuration when I get home.

874
Views
0
Helpful
11
Replies
CreatePlease to create content