Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

Connecting to Aironet 1130AG through Hyperterminal

We have a wired Aironet 1130AG which we cannot connect to. We got a cable to hook it up to a computer with the Hyperterminal. But we don't know the commands to connect to it. Can anyone give us some advice?

Thanks

Mike

3 REPLIES
Hall of Fame Super Red

Re: Connecting to Aironet 1130AG through Hyperterminal

Hi Mike,

You will need these settings on your Hyperterminal session;

Baud rate: 9600

Data: 8 bit

Parity: none

Stop: 1 bit

Flow Control: None

Hope this helps!

Rob

New Member

Re: Connecting to Aironet 1130AG through Hyperterminal

We do have those settings put in. It keeps trying to connect but drops. It will only stay up for maybe two seconds.

Thanks

Mike

New Member

Re: Connecting to Aironet 1130AG through Hyperterminal

We do have those settings put in. It keeps trying to connect but drops. It will only stay up for maybe two seconds.

Thanks

Mike

1226
Views
0
Helpful
3
Replies
CreatePlease to create content