We have a WLC connected to a 6500 Switch, when tried to enable LAG the connectivity goes down, the switch can't ping the controller nor the controller to the switch, we check tha cables, the minigybics, we changed them for new ones,the status of the interfaces is UP UP, we tried revert the config, using LAG disabled and no success, i can't reach the management interface. with the service port i can connect to the controller.
Make sure you have the management and ap-manager interface set to "0" untagged and also make sure the trunk ports are set to native vlan . Also make sure that the trunk port is set to channel-group X mode on.
Transferring Crash file from standby:
Login to the Active WLC in HA.
(Cisco Controller) >transfer upload datatype crash
(Cisco Controller) >transfer upload filename <Desired filename>
(Cisco Controller) >transfer up...
This is the start of a display filter cross reference between Wireshark and OmniPeek.
The 1st installment is a table of advanced filters. More filters will be added as time allows.
It is a living doc, so check back for changes every so often
Please feel ...
I have created a Powershell script to automatically add a Wireless Guest User on Cisco WLCs. (tested on 2500 Series)
The script should be completely self explanatory.
Powershell SNMP Module (Install-Module -Name SNMP)
SNMP Write Access to...