Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Convert AP1200 from VXWorks to IOS using Wlse

The job runs upto 50 percent and status is 'waiting for confirmation' Log also recieved an error 'uploading the .ini file.

3 REPLIES
New Member

Re: Convert AP1200 from VXWorks to IOS using Wlse

Are you using the right IOS Image. You have to also have to create a non-ios template to apply.

Bronze

Re: Convert AP1200 from VXWorks to IOS using Wlse

50% means the image has successfuly been converted. WLSE simply waits for the AP to reboot.

For some reason, AP did not reboot. Try power cycle the AP and it should come back fine.

Blue

Re: Convert AP1200 from VXWorks to IOS using Wlse

Click on the Refresh icon in the Job Run Detail->Job Run Log to update the screen and see exactly whether the job has completed or failed. Conversion Job takes a while than normal to complete, so you may have to wait to check the status

129
Views
0
Helpful
3
Replies
CreatePlease to create content