Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Could not apply interface override

We have just implemented a 5508 controller pair with MSE, Prime, and ISE. The system is working well, but I keep getting the following message in the log of the controller:

[ERROR] apf_policy.c 3383: Could not apply interface override:
  source Override Summation, interface '30', vlanId: 0x1e

 

Our APs are all set for FlexConnect so it seems to be reporting an issue applying the vlan override on an AP, but I have no reported issues of this not working. I cannot find this error anywhere in a reference guide. VLAN 30 is our local flexconnect user subnet.

 

2nd question regards the apf_policy.c 3383. Does this refer to a specific AP? If so is there some cross reference for this 3383 number to an actual AP in my system. I can't find any correlation. I've looked at MAC address, SN, etc.. and I don't see any correlation.

5 REPLIES
New Member

hi, I am having the same

hi,

 

I am having the same error message on flex 7510 controllers as well.

 

Any ideas please, much appreciated

Hall of Fame Super Silver

Might be a cosmetic bug to be

Might be a cosmetic bug to be honest if everything is working fine.  You can open a TAC case so they can identify it as a bug or tell you if there is already a bud id.

-Scott

-Scott
*** Please rate helpful posts ***

Vlan1d:0x1e i.e 30 , can you

Vlan1d:0x1e i.e 30 , can you set no vlan override to vlan 30 in the
ISE and test if the error is thrown again

New Member

Saurav, where in ISE can i

Saurav,

 

where in ISE can i make this change?

Cisco Employee

i think you better approach

i think you better approach TAC to rectify the issue.

594
Views
0
Helpful
5
Replies
CreatePlease to create content