Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Create WCS templates from existing WLC controller?

Hi,

One of my customers implemented a single WLC over a year ago.

They now want to expand with a second WLC and add WCS for management.

WCS is able to retrieve the current config from a controller which is a nice feature. But what i would like to do is use the config from the primary (existing) WLC, convert that into WCS templates, so i can push the templates to the new controller after initial setup.

Is that possible?

Thanks, Marcel

2 REPLIES
New Member

Create WCS templates from existing WLC controller?

Ah, just found out that this is possible.

You can disover templates from an connected controller. These can be use for new controllers...

Hall of Fame Super Silver

Re: Create WCS templates from existing WLC controller?

If your running 4.2.61.0 or later, it's easier to just backup the config of your existing wlc and then open it in a text editor and change the ip address, host name, etc. then just upload that to the new wl after you get it configured.

Make sure you are running the same code on each wlc. Later code supports auto install feature, but if it's just one wlc, it's easier to just edit the file and upload it.

Sent from my iPhone

-Scott
*** Please rate helpful posts ***
620
Views
0
Helpful
2
Replies
CreatePlease login to create content