I integrated CSM 3.1.1 sp3 with ACS Solution Engine 4.1, it seemed a success, but I tried to add a ASA 5540. I add this ASA to ACS before, and I tested, but when I try to add to CSM, CSM give me the error that this device is not added in ACS.
Actually I have two ASA in failover configuration. In ACS I add one entry with the shared ip.
Transferring Crash file from standby: Login to the Active WLC in HA.
From CLI: (Cisco Controller) >transfer upload datatype crash (Cisco
Controller) >transfer upload filename (Cisco
Controller) >transfer upload mode tftp (Cisco Controller) >transfer
This is the start of a display filter cross reference between Wireshark
and OmniPeek. The 1st installment is a table of advanced filters. More
filters will be added as time allows. It is a living doc, so check back
for changes every so often Please feel f...