Okay, thanks for the tip... The controllers had been configured for quite some time so this was something I had never seen them do before..... Very strange that out of the blue after a year or more of running, this happened...
I rebooted the WiSM and everything has been running fine for the last 12 days.... I'll keep an eye on it.
We are running WCS ver. 7.0.164 and WLC ver. 22.214.171.124. We have 8 WISMs and 1 5508 all had the same error and all were fixed with a reboot. Is this happening randomly or have you been able to see any kind of pattern. (Number of days between problem,etc.) Just trying to figure out if doing scheduling reboots during downtime would help prevent this from happening. I have a TAC case open on this issue, will let you know what I find out.
That would be great if you let me know where you get with TAC. From what I can tell it is mostly random in our situation. We haven't been able to associate any rhyme or reason for why it happens or when it happens.We can go 30 + days with no problem and then, boom it is throwing errors again.... I really wish I had an answer. We were planning on upgrading anyway but just haven't found a good time to do so yet because we also run VoIP with the Cisco Cordless phone and people cannot be without them. Our site is 24 / 7 so no time is a good time! Ha Ha! Thanks and please let me know if you get anywhere with TAC. I would appreciate it....
Transferring Crash file from standby:
Login to the Active WLC in HA.
(Cisco Controller) >transfer upload datatype crash
(Cisco Controller) >transfer upload filename <Desired filename>
(Cisco Controller) >transfer up...
This is the start of a display filter cross reference between Wireshark and OmniPeek.
The 1st installment is a table of advanced filters. More filters will be added as time allows.
It is a living doc, so check back for changes every so often
Please feel ...
I have created a Powershell script to automatically add a Wireless Guest User on Cisco WLCs. (tested on 2500 Series)
The script should be completely self explanatory.
Powershell SNMP Module (Install-Module -Name SNMP)
SNMP Write Access to...