When I first configure a WAP and have Radio enabled I cannot see it immediately in available networks on my wireless device. My experience is that it takes a few hours for the connection to show. Is this common? Has anyone had a similar experience? Is there a known resolution for the delay?
Transferring Crash file from standby: Login to the Active WLC in HA.
From CLI: (Cisco Controller) >transfer upload datatype crash (Cisco
Controller) >transfer upload filename (Cisco
Controller) >transfer upload mode tftp (Cisco Controller) >transfer
This is the start of a display filter cross reference between Wireshark
and OmniPeek. The 1st installment is a table of advanced filters. More
filters will be added as time allows. It is a living doc, so check back
for changes every so often Please feel f...