Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

Device was not reachable via SNMP

I am always getting the ''Device was not reachable via SNMP'' error messages from wlse , i confirmed the devices were up & running is there any setttings in wlse i can rectify this error messages.

2 REPLIES

Re: Device was not reachable via SNMP

Make sure the device (AP) is configured properly with SNMP (verify community name, WLSE hostname/IP) and at the same time, WLSE recognised the device with identical snmp community name.

- Configuring WLSE with SNMP:

http://www.cisco.com/en/US/products/sw/cscowork/ps3915/products_installation_guide_chapter09186a008026490f.html#wp1106938

- Configuring Device (IOS) with SNMP

http://www.cisco.com/en/US/products/sw/cscowork/ps3915/products_configuration_guide_chapter09186a00802648f3.html

- Configuring Device (non-IOS) with SNMP

http://www.cisco.com/en/US/products/sw/cscowork/ps3915/products_configuration_guide_chapter09186a00802648f6.html

HTH,

AK

Community Member

Re: Device was not reachable via SNMP

I've found that when this happens, if the device is up and reachable by snmp, removing the device from the WLSE and then letting it be discovered again has always fixed the problem.

1663
Views
4
Helpful
2
Replies
CreatePlease to create content