Here is my scenario. I have a Cisco Cat3550 switch. Three of the ports are set to access mode for vlan 2. My WLSE Express is plugged into one, my 1210 AP is plugged into another, and my laptop is plugged into the third. The switch is my DHCP server.
When the AP or my laptop boot up, they receive IP addresses from the switch correctly. The AP receives its config file from WLSE and is online.
The problem is that when I connect to the wifi, which is assigned to vlan 2, I don't receive an IP address via DHCP. When I'm plugged into the switch I do.
I've attached my config file for the AP. Can anyone tell me what I am doing wrong here?
Transferring Crash file from standby:
Login to the Active WLC in HA.
(Cisco Controller) >transfer upload datatype crash
(Cisco Controller) >transfer upload filename <Desired filename>
(Cisco Controller) >transfer up...
This is the start of a display filter cross reference between Wireshark and OmniPeek.
The 1st installment is a table of advanced filters. More filters will be added as time allows.
It is a living doc, so check back for changes every so often
Please feel ...
I have created a Powershell script to automatically add a Wireless Guest User on Cisco WLCs. (tested on 2500 Series)
The script should be completely self explanatory.
Powershell SNMP Module (Install-Module -Name SNMP)
SNMP Write Access to...