Yes, you can do this. Via the GUI, you have the option of selecting the specific RADIUS server you want to use for a selected SSID. So, after defining the VLANs and RADIUS Servers, you'd configure each SSID on the "SSID Manager" page. On that page, you have an option to set "Server Priority." You'd want to select the "customize" radio button and use the dropdown to select the RADIUS server you want to use for the SSID.
I've attached the output of a command line configuration for your reference as well. The only caveats I warn about are: 1. That the servers must all be reachable from the ip address of the AP; 2. that the ip address of the AP must be configured in RADIUS as the "NAS" or "AAA Client" ip address; and 3. that the keys match on both RADIUS and the AP for each server (in the CLI output, these were configured as 'test10', 'test20', and 'test30').
IntroductionHow to use the Wireless LAN Controller Configuration Analyzer (WLCCA)
Javier Contreras is a Senior Tech Lead for the Wireless Business Unit in Cisco, with over 2 decades of experi...
< PRE >
(#)For this reason being that : - application that doesn't use multicast, sends one copy of each packet ( data unit of traffic at layer 3 ) to each client (" who seeks the traffic ).- application that does use multicast, sends ...
Transferring Crash file from standby:
Login to the Active WLC in HA.
(Cisco Controller) >transfer upload datatype crash
(Cisco Controller) >transfer upload filename <Desired filename>
(Cisco Controller) >transfer up...