You need to configure wlan override on the ap for each radio. So basically you need to click on wireless and then click on 802.11a/n or 802.11b/g/n and configure the radio. Wlan Override is located on the bottom left side. Enable it and then choose which SSID you want on that AP.
Transferring Crash file from standby: Login to the Active WLC in HA.
From CLI: (Cisco Controller) >transfer upload datatype crash (Cisco
Controller) >transfer upload filename (Cisco
Controller) >transfer upload mode tftp (Cisco Controller) >transfer
This is the start of a display filter cross reference between Wireshark
and OmniPeek. The 1st installment is a table of advanced filters. More
filters will be added as time allows. It is a living doc, so check back
for changes every so often Please feel f...