Shutting down the radios at night to save energy ain't going to do you any good unless you are talking about THOUSANDS of AP. The radios only chew up very minimal watts of power.
You can, but not recommendable, power off the AP outside office hours using time-based ACL, however, your AP must be connected to a PoE port. If your AP is connected via a power brick or a power injector you'll need to find a cut-off timer there.
Transferring Crash file from standby:
Login to the Active WLC in HA.
(Cisco Controller) >transfer upload datatype crash
(Cisco Controller) >transfer upload filename <Desired filename>
(Cisco Controller) >transfer up...
This is the start of a display filter cross reference between Wireshark and OmniPeek.
The 1st installment is a table of advanced filters. More filters will be added as time allows.
It is a living doc, so check back for changes every so often
Please feel ...
I have created a Powershell script to automatically add a Wireless Guest User on Cisco WLCs. (tested on 2500 Series)
The script should be completely self explanatory.
Powershell SNMP Module (Install-Module -Name SNMP)
SNMP Write Access to...