From memory, the latest WLC software (and possibly older versions) allow channel 165 to be disabled. I can not find this functionality on the 1250 or 1140 (autonomous). That is, I want to exclude DFS from picking ch 165, obviously because I would like a 40 Mhz channel and not 20 MHz as is the case when ch 165 is picked due to being at the end of the band? This is when the APs are configured to extend above the primary channel.
< PRE >
(#)For this reason being that : - application that doesn't use multicast, sends one copy of each packet ( data unit of traffic at layer 3 ) to each client (" who seeks the traffic ).- application that does use multicast, sends ...
Transferring Crash file from standby:
Login to the Active WLC in HA.
(Cisco Controller) >transfer upload datatype crash
(Cisco Controller) >transfer upload filename <Desired filename>
(Cisco Controller) >transfer up...
This is the start of a display filter cross reference between Wireshark and OmniPeek.
The 1st installment is a table of advanced filters. More filters will be added as time allows.
It is a living doc, so check back for changes every so often
Please feel ...