We are currently testing AP1242 (used as Workgroup bridge) to replace our current client bridge device that uses PEAPv0 as authentication protocol. The assumption was that AP1242 (as WGB) supports PEAP (v0 or v1). But the ACS server failure log is telling us differently ("EAP Type not configured"). Does AP1242 (as WGB) supports PEAP? What authentication protocol does AP1242 (as WGB) uses? Is it EAP-FAST? Any info you can share is much appreciated.
I don't think there is any restriction that WGB does not support PEAP. WGB will support any EAP authentication. If its not working, we need to look at the configuration to see if we have missed something. Can u post the configuration?
Transferring Crash file from standby: Login to the Active WLC in HA.
From CLI: (Cisco Controller) >transfer upload datatype crash (Cisco
Controller) >transfer upload filename (Cisco
Controller) >transfer upload mode tftp (Cisco Controller) >transfer
This is the start of a display filter cross reference between Wireshark
and OmniPeek. The 1st installment is a table of advanced filters. More
filters will be added as time allows. It is a living doc, so check back
for changes every so often Please feel f...