Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

Download WLC 2504 Config and Upload to a WLC 5508

Hi Community.

Is there a way to Download WLC 2504 Config and Upload it to a WLC 5508. As I know this is not possible but, is it possible to import a part of the config to a WLC 5508 controller. The config of the customer isn't complicated but he has a bunch of AP's with configured AP Names and Locations.

It would be good to export the AP's and import it to the WLC 5508.

Is there a solution for that ?

best Regards Patrick

1 ACCEPTED SOLUTION

Accepted Solutions
VIP Purple

Hi Patrick,AP Name &

Hi Patrick,

AP Name & Locations won't be in a WLC config back up (rather remain in AP itself). So if you move APs to 5508 (from 2504), name & location  information of those AP will be there.

If you want to upload a part of configuration, you can simply take a back up of WLC configuration & apply required lines via CLI.

 

HTH

Rasika

**** Pls rate all useful responses ****

 

2 REPLIES
VIP Purple

Hi Patrick,AP Name &

Hi Patrick,

AP Name & Locations won't be in a WLC config back up (rather remain in AP itself). So if you move APs to 5508 (from 2504), name & location  information of those AP will be there.

If you want to upload a part of configuration, you can simply take a back up of WLC configuration & apply required lines via CLI.

 

HTH

Rasika

**** Pls rate all useful responses ****

 

Bronze

Yes it is possible if WCS is

Yes it is possible if WCS is configure but it is recommended you do the manual process.

 

Further more as mention earlier AP Name & Locations will stick there.

 

For manual process like:

 

#copy running-config flash:backup-config

# transfer download datatype ?

 

 

And then on other WLC.

 

# transfer upload datatype ?  [it should be config]

 

 

 

468
Views
5
Helpful
2
Replies
CreatePlease to create content