Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Duplicate SSID's

I'm trying to create duplicate SSID's with different interfaces.  I'm getting an error that says the SSID must be unique, or have different layer 2 authentication.

Our goal is to have users create one profile on their wireless device, and be able to travel among all of our locations, but make it easy for our service desk to tell where someone is by IP.   

I thought this would be possible by creating AP groups, but from what I'm reading it looks like this is not possible?

3 REPLIES
Hall of Fame Super Gold

Can be done but it won't be

Can be done but it won't be easy.  

 

You need to create a series of dynamic interfaces.  You have one main interface where your SSID is tied to.  

 

Next you need to create DHCP scope for your APs at each site.  The DHCP scope has to be unique.  You can't have APs in SITE A get an IP address from Site B.  Site A DHCP scope and Site B DHCP scope has to be unique.  

 

Same thing with DHCP scope for wireless clients.  They have to be unique.   These scopes are tied to the dynamic interfaces (of each site).  For example, you create four dynamic:  

 

1.  Main_link:  10.1.1.0/24; 

2.  Site_A:  10.2.1.0/23; 

3.  Site B:  10.3.1.0/23;

4.  Site C:  10.4.1.0/24  (it's a small site so the subnet mask is small)

 

The default gateway of Site A, B, and C resides in your router.  

 

Next, the hard part:  You'll need to create a few scripts (like PERL) to pull data from the RADIUS authentication server.  Your script will say that all authenticated users will be plumbed back to the Main_Link dynamic interface. 

Bronze

Hi,As far as i know it is not

Hi,

As far as i know it is not possible because you can create multiple SSIDs but not duplicate SSID in a single Network.

That is exactly what AP

That is exactly what AP groups are used for.

 

So long as the user is off the WLC for the idle timeout, they will get an IP address from the appropriate interface for the AP group

 

HTH,

Steve

HTH, Steve ------------------------------------------------------------------------------------------------ Please remember to rate useful posts, and mark questions as answered
1011
Views
0
Helpful
3
Replies
CreatePlease login to create content