Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Attention: The Community will be in read-only mode on 12/14/2017 from 12:00 am pacific to 11:30 am.

During this time you will only be able to see content. Other interactions such as posting, replying to questions, or marking content as helpful will be disabled for few hours.

We apologize for the inconvenience while we perform important updates to the Community.

mhs
New Member

EAP authentication MS IAS RADIUS across Subnets without DC

I have 2 sites set up using MS IAS 2003 RADIUS server and Cisco 1230 APs. Both site that I have configured have MS DCs local and both sites perform USER and HOST based authentication. I have attempted to set up a third site, but this site is unique b/c it does not have a DC local. At this site the authentication apears to be timing out even though I set all timeouts to the highest intervals.

I need the PC to be authenticated at the Windows login screen, then I need the usercredentials passed to a DC, then I need them to be allowed access to the Network. THe device is requiring a local cached user to gain access then it is authenticating and assigning an IP. However, I need this all to happen at the loginscreen prior to loggin in b/c I do not allow local cached profiles.

I had this simmilar problem at a nother site and adjusting the timeouts corrected that but a DC was also local.

Any ideas are appreciated

248
Views
0
Helpful
0
Replies
CreatePlease to create content