Hi, I have ACS Server generated certificate and the validy for this cert is only for 1 year. after 1 year i have to renew the cert and in the client site i have to install the client again. Is there any way i can push the newly generated cert to the client automatically. any suggestion ?
Hi thank you for your reply, I dont have any 3rd party Certificate server so am using a self-generated Cert which generated in ACS Server for the client Authentication. Now every year i need to renew the certificate in the ACS Server and install in the ACS Server and also on the client site. Limitation in ACS Server Self generated cert was the validity is only for 1 year. After 1 year when i recreate another cert and install in the ACS Server i need install in all the client as well. Is there any way i can just push the certificate from the ACS to Client instaed of going to all client machine one by one.
Hi, i got no access to the ACS now as am in a different location. we have enabled PEAP with EAP-MSCHAPv2 & EAP-GTC, and with this we have installed a "Self-Singed Ceritificate" in the ACS Server. Now after 1 year i have renewed the Certificate and for the client i need to install in each client again. any posibility for me to push the ceritificate from ACS or any other suggestion.
That is weird... PEAP does not require you to install a cert on the client side. Usually if you don't have "Validate Server CA" configured on the client side, the client doesn't care if there is a new certificate. Even if you validate the CA and you install a new cert, as long as the ACS is the same, you should still not see any distruptions. How are your clients configured?
hi, I believe when you configure your client machine using "PEAP with EAP-MSCHAPv2 and WPA 2 enterprise, you need to validate server certificate. also authenticate the user credential over the AD Server.
Transferring Crash file from standby:
Login to the Active WLC in HA.
(Cisco Controller) >transfer upload datatype crash
(Cisco Controller) >transfer upload filename <Desired filename>
(Cisco Controller) >transfer up...
This is the start of a display filter cross reference between Wireshark and OmniPeek.
The 1st installment is a table of advanced filters. More filters will be added as time allows.
It is a living doc, so check back for changes every so often
Please feel ...
I have created a Powershell script to automatically add a Wireless Guest User on Cisco WLCs. (tested on 2500 Series)
The script should be completely self explanatory.
Powershell SNMP Module (Install-Module -Name SNMP)
SNMP Write Access to...