EAP-FAST with Manual .pac provisioning AP 1010 w/ ACS
I am able to authenticate with EAP-FAST auto provisioning but I am hesitant to use it due to MITM attacks. I generated a manual .pac file on the ACS for my userid and loaded it on the client no problem. But I am unable to authenticate - no errors in the ACS failed attempts log. Where is the .pac file stored in the ACS and do I have to move it or point to it in some other way so that when I logon with my client it matches up? Thank You
Re: EAP-FAST with Manual .pac provisioning AP 1010 w/ ACS
I generated a manual .pac file using the ACS utility CSUtil. MY ACS version is 3.3 and the file is under the C:\Program Files\CiscoSecure ACS vX.X\Utils and the file is created in the same directory. I did an import of this file ( I copied the file from the ACS to a thumbdrive ) on my Intel PROSet utility for an EAP-Fast profile. BUT when I try and connect I am unable to. I was able to connect when auto-pac is being used but I want to use manual.
Transferring Crash file from standby:
Login to the Active WLC in HA.
(Cisco Controller) >transfer upload datatype crash
(Cisco Controller) >transfer upload filename <Desired filename>
(Cisco Controller) >transfer up...
This is the start of a display filter cross reference between Wireshark and OmniPeek.
The 1st installment is a table of advanced filters. More filters will be added as time allows.
It is a living doc, so check back for changes every so often
Please feel ...
I have created a Powershell script to automatically add a Wireless Guest User on Cisco WLCs. (tested on 2500 Series)
The script should be completely self explanatory.
Powershell SNMP Module (Install-Module -Name SNMP)
SNMP Write Access to...