am using CISCO ACS SE to authenticate my users who connect to my wireless network from the microsoft AD..am using EAP-PEAP.
the authentication works fine the problem is that after authenticating and associating my Client connects for about 5 minutes and reconnects again and it does this continously in intervals of 5 minutes..whare could i have gone wrong.
I don't think there is any issue with the authentication server unless you have set the client session interval to as low as 5 mins. Could you check what is the client session interval configured? Does it happen to all clients?
Transferring Crash file from standby: Login to the Active WLC in HA.
From CLI: (Cisco Controller) >transfer upload datatype crash (Cisco
Controller) >transfer upload filename (Cisco
Controller) >transfer upload mode tftp (Cisco Controller) >transfer
This is the start of a display filter cross reference between Wireshark
and OmniPeek. The 1st installment is a table of advanced filters. More
filters will be added as time allows. It is a living doc, so check back
for changes every so often Please feel f...