Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

EAPOL-key M2 with invalid MIC (WLC 4.1.171.0)

I have a lot of client in one configuration who have problem with the message:

EAPOL-key M2 with invalid MIC

Config:

4402-12 in 4.1.171.0 (and ER) sw release

AP1242 with 2 4941 in diversity mode

SSID in WPA-TKIP PSK and DHCP on the WLC.

A lot of client can't connect to the switch. With Intel card, i have try the lasted drivers, and it's ok, but with some device like Intermec on windows mobile, it's not working. You can look the trace in the file log.

Some idea ?

4 REPLIES
Silver

Re: EAPOL-key M2 with invalid MIC (WLC 4.1.171.0)

Upgrade the controllerto the latest version

New Member

Re: EAPOL-key M2 with invalid MIC (WLC 4.1.171.0)

It's already in the latest version: 4.1.171.0 and 4.1.171.0 ER

New Member

Re: EAPOL-key M2 with invalid MIC (WLC 4.1.171.0)

I just had a few problems with the same error. It turned out that this was an issue with the client device NEEDING the key to be entered in HEX (even though it would take an ASCII if you typed it). I converted the ASCII PSK I'd configured on the controller into HEX and entered it on the client, and it works fine. You might want to try that if you haven't already.

New Member

Re: EAPOL-key M2 with invalid MIC (WLC 4.1.171.0)

hi there,

if MFP is enabled globally, and in the SSID too, set Client protection to "allowed". seems like MFP it?s set to "required"

1666
Views
0
Helpful
4
Replies
CreatePlease to create content