Trying to set up both an Employee and Hotspot ssid connection. The Hotspot is working fine. The Employee is not broadcasting SSID (by design) and will not connect from a manually configured preferred network entry. Also - Dot11Radio0 interface is working - Dot11Radio1 is in reset mode. Can someone please take a look at the attached config and to see where I'm going wrong?
Transferring Crash file from standby:
Login to the Active WLC in HA.
(Cisco Controller) >transfer upload datatype crash
(Cisco Controller) >transfer upload filename <Desired filename>
(Cisco Controller) >transfer up...
This is the start of a display filter cross reference between Wireshark and OmniPeek.
The 1st installment is a table of advanced filters. More filters will be added as time allows.
It is a living doc, so check back for changes every so often
Please feel ...
I have created a Powershell script to automatically add a Wireless Guest User on Cisco WLCs. (tested on 2500 Series)
The script should be completely self explanatory.
Powershell SNMP Module (Install-Module -Name SNMP)
SNMP Write Access to...