Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

Enable WPA on a Autonomous 1252AG

bandwidth drops from 270Mpbs to 48Mbps when WPA is enabled. Is there a work around? Thanks

2 REPLIES
Silver

Re: Enable WPA on a Autonomous 1252AG

Yes: The workaround is to use WPA2 rather than WPA.

The AP cannot offer N datarates if TKIP or WEP encryption is enabled. The only supported encryption modes for N rate are AES or no encryption.

New Member

Re: Enable WPA on a Autonomous 1252AG

thanks for your help

154
Views
0
Helpful
2
Replies
CreatePlease to create content