Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

Enabling Dynamic WEP on existing AP

I currently have a 350 ap 11.10 firmware with 2 workgroup bridge clients running 8.65 firmware. The ap is running LEAP with cisco secure acs 2.6. when i enable dynamic wep, my clients show in the association page that wep is enabled, but i lose all connection with them. they are eap associated and authenticated, i just can not ping them or perform a link test to them. Any ideas Why?

thanks for the help

2 REPLIES

Re: Enabling Dynamic WEP on existing AP

Often times complex troubleshooting issues are best addressed in an interactive session with one of our trained technical assistance engineers. While other forum users may be able to help, it’s often difficult to do so for this type of issue.

To utilize the resources at our Technical Assistance Center, please visit http://www.cisco.com/tac and to open a case with one of our TAC engineers, visit http://www.cisco.com/tac/caseopen

If anyone else in the forum has some advice, please reply to this thread.

Thank you for posting.

New Member

Re: Enabling Dynamic WEP on existing AP

Actually, i have figured it out. after you turn on the dynamic wep, you must manually reboot all clients for them to receive the encrytpion keys. thanks though..

178
Views
0
Helpful
2
Replies
CreatePlease to create content