I am using Wireless Control System (WCS) 6 and when I try to add data points in a custom calibration model I created, I get an error message "No data points collected when starting from location (X,Y)" only when using Intel 5100 AGN as the client. I know that in order to add Data Points, I need to have a wireless card that supports Cisco CCX, this Intel card supports CCX 4.
I have done added data points using my older computer that uses an older Intel card and it works fine. I used another computer that has a Dell Wireless 1510 Wireless-N card and it works too. The driver on the Intel 5100 AGN is 13.1.1.1(13/01/2010)
Is there a solution to this or is the Intel 5100 AGN just not supported?