cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
2348
Views
0
Helpful
1
Replies

error messages in wlc syslog

Joerg Karschau
Level 1
Level 1

hello,

perhaps somebody can help me with these error messages i receive from the wlc:

Oct 26 09:07:21.073 apf_wme_utils.c:2640 APF-4-RCV_ACTION_FRM_WITH_CODE: Received Action frame with code 2 from mobile station 00:1D:A2:30:E7:4D

Oct 26 00:06:57.271 apf_80211.c:4950 APF-4-PROC_DOT11_MAC_MGMT_DATA_FAILED: Could not Process 802.11 MAC mgmt Data. Invalid toDs/fromDs bit set - packet ignored.

Oct 26 00:06:57.271 apf_wme_utils.c:2640 APF-4-RCV_ACTION_FRM_WITH_CODE: Received Action frame with code 2 from mobile station 00:1D:45:1B:D3:7A

Oct 26 00:06:57.272 apf_80211.c:4950 APF-4-PROC_DOT11_MAC_MGMT_DATA_FAILED: Could not Process 802.11 MAC mgmt Data. Invalid toDs/fromDs bit set - packet ignored.

Oct 26 00:06:57.272 apf_wme_utils.c:2640 APF-4-RCV_ACTION_FRM_WITH_CODE: Received Action frame with code 2 from mobile station 00:1D:45:1B:D3:7A

Oct 26 00:06:57.272 apf_80211.c:4950 APF-4-PROC_DOT11_MAC_MGMT_DATA_FAILED: Could not Process 802.11 MAC mgmt Data. Invalid toDs/fromDs bit set - packet ignored.

Oct 26 00:06:57.272 apf_wme_utils.c:2640 APF-4-RCV_ACTION_FRM_WITH_CODE: Received Action frame with code 2 from mobile station 00:1D:45:1B:D3:7A

and the next block of messages:

Oct 26 09:41:25.603 1x_auth_pae.c:3127 DOT1X-6-CCKM_UPDATE: CCKM: 00:1b:d4:54:b0:ef. Parameter name: CCKM, Param value: 35.

Oct 26 09:41:25.643 iapp_socket_task.c:580 IAPP-3-MSGTAG015: iappSocketTask: iappRecvPkt returned error

Oct 26 09:41:30.573 1x_auth_pae.c:3127 DOT1X-6-CCKM_UPDATE: CCKM: 00:1d:45:1c:0b:d2. Parameter name: CCKM, Param value: 4.

Oct 26 09:41:30.617 iapp_socket_task.c:580 IAPP-3-MSGTAG015: iappSocketTask: iappRecvPkt returned error

Oct 26 09:41:32.931 1x_auth_pae.c:3127 DOT1X-6-CCKM_UPDATE: CCKM: 00:1b:d4:58:e8:d5. Parameter name: CCKM, Param value: 37.

Oct 26 09:41:32.986 iapp_socket_task.c:580 IAPP-3-MSGTAG015: iappSocketTask: iappRecvPkt returned error

Oct 26 09:41:39.537 1x_auth_pae.c:3127 DOT1X-6-CCKM_UPDATE: CCKM: 00:1d:45:1b:d3:7a. Parameter name: CCKM, Param value: 8.

Oct 26 09:41:39.701 iapp_socket_task.c:580 IAPP-3-MSGTAG015: iappSocketTask: iappRecvPkt returned error

Oct 26 09:41:42.034 1x_auth_pae.c:3127 DOT1X-6-CCKM_UPDATE: CCKM: 00:1d:a2:30:e7:4d. Parameter name: CCKM, Param value: 24.

Oct 26 09:41:42.140 iapp_socket_task.c:580 IAPP-3-MSGTAG015: iappSocketTask: iappRecvPkt returned error

Oct 26 09:41:44.908 1x_auth_pae.c:3127 DOT1X-6-CCKM_UPDATE: CCKM: 00:1d:45:1c:0b:d2. Parameter name: CCKM, Param value: 5.

Oct 26 09:41:44.986 iapp_socket_task.c:580 IAPP-3-MSGTAG015: iappSocketTask: iappRecvPkt returned error

these two message blocks are repeated all over the time. we are using one wlc-4404, two acs and about 80 1131ag lwapp access points at the moment.

firmware release is 4.1.185. the 7921's are using the firmware 1.0.4. we are using eap-fast for the 7921 phones.

best regards,

joerg

edit from my side:

the message: "Could not Process 802.11 MAC mgmt Data. Invalid toDs/fromDs bit set - packet ignored." appears every time when there is an incoming call for a pick up group, which is configured on the 7921's phones.

1 Reply 1

irisrios
Level 6
Level 6

Messgaes in Block 2 is due to IAPP. IAPP is the protocol used for AP to AP communication and also by CCX clients for management communication. There is a known issue with Intel clients were they send the incorrect length in the IAPP packets they send to the controller. Upgrade the client software.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Review Cisco Networking products for a $25 gift card