error RTOS update for Cisco Wireless Controller AIR-CT2500-K9
Hello experts, I have problem when I want to update images for WLC,
============================================================ Boot Loader Menu ============================================================
1. Run primary image (Bad image type) - Active 2. Run backup image (Image not found) 3. Change active boot image 4. Clear configuration 5. Format FLASH Drive 6. Manually update images
------------------------------------------------------------ Enter selection: 6 Launching... Launching images... init started: BusyBox v1.6.0 (2009-02-03 04:56:32 EST) multi-call binary Mount failed for selinuxfs on /selinux: No such file or directory starting pid 655, tty '': '/etc/init.d/rcS' Use DHCP for ip configuration (Y/n)? n Enter switch IP address: 10.10.0.1 Enter switch netmask: 255.255.255.0 Enter switch gateway: 10.10.0.10 Enter TFTP server IP address: 10.10.0.10
You have entered: IP Address : 10.10.0.1 Netmask : 255.255.255.0 Gateway : 10.10.0.10 Server Ip Addr : 10.10.0.10
Is this correct(y/N)? y
!!! WARNING updating using .aes or unapproved files will disable this unit !!!
Do you want to update RTOS (y/N)? y
Do you want to update Primary Or Secondary Image (P/s)? P
Enter filename for RTOS update: AIR-CT2500-K9-1-8-0-0-FUS RTOS update Done
Enter filename for FP update: AIR-CT2500-K9-7-4-100-0.aes FP update Done Do you want to update an AP image (y/N)? y
Do you want to update Primary Or Secondary Images (P/s)? P Enter AP image filename for tftp download: AIR-CT2500-K9-7-4-100-0.aes cdir= ver=. ap_img= Not a valid AP image, try again. Do you want to update another AP image (y/N)? y
Do you want to update Primary Or Secondary Images (P/s)? P Enter AP image filename for tftp download: AIR-CT2500-K9-7-5-102-0.aes cdir= ver=. ap_img= Not a valid AP image, try again.
Transferring Crash file from standby:
Login to the Active WLC in HA.
(Cisco Controller) >transfer upload datatype crash
(Cisco Controller) >transfer upload filename <Desired filename>
(Cisco Controller) >transfer up...
This is the start of a display filter cross reference between Wireshark and OmniPeek.
The 1st installment is a table of advanced filters. More filters will be added as time allows.
It is a living doc, so check back for changes every so often
Please feel ...
I have created a Powershell script to automatically add a Wireless Guest User on Cisco WLCs. (tested on 2500 Series)
The script should be completely self explanatory.
Powershell SNMP Module (Install-Module -Name SNMP)
SNMP Write Access to...