Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

Error when trying to modifyaccess point name in WCS

When attempting to modify the Access Point name in WCS we receive the following error:

You must correct the following error before proceeding:

Error: Global Username and Password are not configured on the associated controller. Please configure username password on the associated controller before disabling 'Override Global Username Password

Currently we have 4 wisdoms controlled via WCS, above credentials requested in the error are not applied anywhere throughout the system.

WCS version is Version 5.1.64.0

2 REPLIES
Silver

Re: Error when trying to modifyaccess point name in WCS

you need to have defined AP access uid/pw credentials. Here are the commands for 4.2 and later, that add an enable secret too. I hope it may help you

New Member

Please refer Cisco Wireless

Please refer Cisco Wireless LAN Controller Configuration Guide, Release 7.4 on this link http://www.cisco.com/c/en/us/td/docs/wireless/controller/7-4/configuration/guides/consolidated/b_cg74_CONSOLIDATED/b_cg74_CONSOLIDATED_chapter_01101011.html

531
Views
0
Helpful
2
Replies
CreatePlease to create content