cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
383
Views
0
Helpful
1
Replies

failed tacacs+ user authentication

I want to autenticate admin users in a AP350 with v12.01T1, with a tacacs+ server (ACS v3.1).

I configured on the AP350 an authentication server, port 49, tacacs, correct key, etc.

I configured the aaa client, users, etc, and I obtain in the ACS "failed attempts" this message: "CS password invalid". I am sure the password I typed was correct.

Does anyone know what could be happening?

TIA

1 Reply 1

rprpalmer
Level 1
Level 1

I had the same thing. Make sure that if you are doing MAC authentication or any authentication. Make sure you observe case sensitvity. The MAC addresses are sent to the ACS server as all lower case.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: