Wondering if anyone has had any real luck with configuring protocol filters on APs- looks like the ethertype filters are pretty limited. Lets say I have a group of wireless users that are infected with gaobot (or whatever), and I want to block traffic on a certain tcp port at the AP- can this be done? My WLSE could push the config to my devices, if I could figure out where or how to put a port-based filter (beyond the limited list of supported ethertypes that I can dig up in old 350 docs). Am I off in left field, or is this doable? The attached switches would be another point of acl-style control, but don't have that easy of a way to push configs like with WLSE...
Transferring Crash file from standby:
Login to the Active WLC in HA.
(Cisco Controller) >transfer upload datatype crash
(Cisco Controller) >transfer upload filename <Desired filename>
(Cisco Controller) >transfer up...
This is the start of a display filter cross reference between Wireshark and OmniPeek.
The 1st installment is a table of advanced filters. More filters will be added as time allows.
It is a living doc, so check back for changes every so often
Please feel ...
I have created a Powershell script to automatically add a Wireless Guest User on Cisco WLCs. (tested on 2500 Series)
The script should be completely self explanatory.
Powershell SNMP Module (Install-Module -Name SNMP)
SNMP Write Access to...