We recently loaded our Cisco 350 bridges with firmware 12.03T. We setup user manager with a userid and password. We have noticed that you must enter your userid and password twice with 12.03T. Is this a known caveat?
FWIW, I have seen this too. But considering this is the first firmware version I've seen that doesn't constantly flap (associate/reassociate) I am gladly logging in twice rather than back revision. I am just hoping that it stops the br350's from freezing up (red ethernet light, unit stops responding). So far so good on all fronts though.
Transferring Crash file from standby: Login to the Active WLC in HA.
From CLI: (Cisco Controller) >transfer upload datatype crash (Cisco
Controller) >transfer upload filename (Cisco
Controller) >transfer upload mode tftp (Cisco Controller) >transfer
This is the start of a display filter cross reference between Wireshark
and OmniPeek. The 1st installment is a table of advanced filters. More
filters will be added as time allows. It is a living doc, so check back
for changes every so often Please feel f...
I have created a Powershell script to automatically add a Wireless Guest
User on Cisco WLCs. (tested on 2500 Series) The script should be
completely self explanatory. Prerequisites: Powershell SNMP Module
(Install-Module -Name SNMP) SNMP Write Access to y...