Hi, New to the forum. Thanks in advance for your help. Using Cisco E2500 with a Dell PC, Win 7. I have been having some connectivity issues lately. After some troubleshooting this morning I decided to try to upgrade my firmware. The first two times I attempted the upgrade it started fine, but up around 90some percent it gave me a fail error message and dropped the connection. I hardwired and tried again with the same results, install of the firmware started fine, but around 90 some persent it gave me a fail message while dropping the connection. Stumped. Thanks again.
Transferring Crash file from standby: Login to the Active WLC in HA.
From CLI: (Cisco Controller) >transfer upload datatype crash (Cisco
Controller) >transfer upload filename (Cisco
Controller) >transfer upload mode tftp (Cisco Controller) >transfer
This is the start of a display filter cross reference between Wireshark
and OmniPeek. The 1st installment is a table of advanced filters. More
filters will be added as time allows. It is a living doc, so check back
for changes every so often Please feel f...