Cisco Support Community
Showing results for 
Search instead for 
Did you mean: 

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

FlexConnect (H-REAP) WLAN Mapping

Hi There ...

I have been hitting my head against a wall here for a couple of dates and still not sure if it is my bad or a bug.

We have a 5508WLC recently updated to since we are using CAP3602I-N-K9, this AP is intended to work as a H-REAP device and eventhough it is registering to the controller I can't get to see the WLANS on the list to map it to the local VLANS

I have verified and the WLAN is configured for local switching also have followed the steps listed here:

Still Can't see the WLANs under the Flexconnect tab on the AP?

Am I missing something? has anyone else experienced this before?

thank you

Everyone's tags (3)

FlexConnect (H-REAP) WLAN Mapping

You tried rebooting the AP? Are you sure you try to configure the correct AP and not mixing with another one?

Check if you are using AP groups! If the AP belongs to an AP gropu make sure that the group configured to broadcast hte needed WLANs.



Rating useful replies is more useful than saying "Thank you"
New Member

FlexConnect (H-REAP) WLAN Mapping

Hi Amjad,

Thank you for your response, so I got it working however I am not happy yet

AP was under the default group and the WLAN was there as expected, however I had to create a new group ot get it working

I would expect it to work under the default group anyway ... am I wrong?

CreatePlease to create content