Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Forcing Mesh AP to join a particular parent

Hi there;

I have a setup of 10 1522 APs (4 RAPs and 6 MAPs). Two of them (One RAP and one MAP) are placed bit away from the remaining ones. The two remote APs function correctly as desired (the remote MAP selects nearest RAP as parent) but when the RAP looses its ethernet connection due to wired network failure; the MAP joins a remote RAP with very low SNR and stays at it even when the desired RAP comes up again.

Is there any way we can set a priority that the MAP joins intended RAP as soon as it comes alive again?

Thanks,

1 ACCEPTED SOLUTION

Accepted Solutions
Gold

Re: Forcing Mesh AP to join a particular parent

The 1520's don't currently support background scanning. The result of this is the condition you described. Bug CSCsw28993 was filed to have background scanning added to the 1520's.

2 REPLIES
Gold

Re: Forcing Mesh AP to join a particular parent

The 1520's don't currently support background scanning. The result of this is the condition you described. Bug CSCsw28993 was filed to have background scanning added to the 1520's.

New Member

Re: Forcing Mesh AP to join a particular parent

Thanks a lot. It was really helpful

162
Views
0
Helpful
2
Replies
CreatePlease login to create content