We have installed the WCS software and it grabbed port 21 in addition to the tftp port. When, we tried to ftp into this box, we could not get authenticated with either local or tacacs credentials. Does anybody happen to know where these credentials are set?
thanks for your response...Unfortunately, I was not the one who installed the WCS, so I would not have the first hand knowledge about the install phase..Are u saying that during the WCS install, the system prompts u to assign FTP & TFTP passwords and the user-id? Thanks again..
Transferring Crash file from standby:
Login to the Active WLC in HA.
(Cisco Controller) >transfer upload datatype crash
(Cisco Controller) >transfer upload filename <Desired filename>
(Cisco Controller) >transfer up...
This is the start of a display filter cross reference between Wireshark and OmniPeek.
The 1st installment is a table of advanced filters. More filters will be added as time allows.
It is a living doc, so check back for changes every so often
Please feel ...
I have created a Powershell script to automatically add a Wireless Guest User on Cisco WLCs. (tested on 2500 Series)
The script should be completely self explanatory.
Powershell SNMP Module (Install-Module -Name SNMP)
SNMP Write Access to...