If I understand what you are asking.... You need to setup the Intel and Broadcom Utility to obtain a network connection prior to login. This way it will be as if wired..... device will be on the network, client logs in and scripts... etc will happen.
I am using the broadcom utility and intel utility but it still didn't work reliably. The machine policies weren't running half the time because the card didn't initialize yet. There is a reg edit that we are testing now that tells windows to not process policies until the card comes up. As a side note, the Broadcom is a little cumbersome to setup. I was wondering if anyone knows of a way to make and executable like the intel client will do. Thanks
Transferring Crash file from standby: Login to the Active WLC in HA.
From CLI: (Cisco Controller) >transfer upload datatype crash (Cisco
Controller) >transfer upload filename (Cisco
Controller) >transfer upload mode tftp (Cisco Controller) >transfer
This is the start of a display filter cross reference between Wireshark
and OmniPeek. The 1st installment is a table of advanced filters. More
filters will be added as time allows. It is a living doc, so check back
for changes every so often Please feel f...