Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Guest Controller

I am facing some problems with guest controller configuration. I have one local controller inside the network and one guest controller connected to the outside network. I will configure the dhcp pool in the guest controller. But the problem is that where will i define the guest vlan. i think we have to configure it in the pix. if we have to define it in the pix, we have to create the same interface on the local controiller also. could you please send me the pix configuration to achieve this.

1 REPLY
Silver

Re: Guest Controller

Yes you have to create the VLAN configuration in PIX. You can create the VLAN using the subinterfaces of the Ethernet interfaces of PIX.

The following URL helps you in configuring VLAN in PIX:

http://www.cisco.com/en/US/products/hw/vpndevc/ps2030/products_configuration_example09186a00806ab788.shtml#conf

129
Views
0
Helpful
1
Replies