Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

Guest WLAN and VLAN out of 2811 w WLC module

Using a WLC 2006 or 4000 series, there is

no problem getting the traffic on a "guest WLAN" connected to a wired VLAN.

But, how to do that when one is using

a 2811 with a WLC module?

Now the "guest WLAN" connects internally

to the 2811 "interface wlan-controller 1/0" as a VLAN on a subinterface. I do not want the default GW for that VLAN within the 2811. Instead I just want to get it out at layer 2. Transparent bridging between a subinterface "int wlan-controller1/0.x" and "int fastethernet0/1.x" failed. Any ideas?

1 REPLY
133
Views
0
Helpful
1
Replies
CreatePlease to create content