Welcome to Cisco Support Community. We would love to have your feedback.
For an introduction to the new site, click here. And see here for current known issues.
I got the AP541n and I want to add an vlan, which has guest status. I would like to have only low traffic in this vlan, f.e. only 5MHZ Rate and no access to the network of the other vlans
vlan0 is the default and has full rights and full traffic.
My AP541 has the firmware 1.7.2 and here i can only change this parameters for ALL vlans. I found no way, to change parameters or QoS separatly in the vlans.