Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

H-REAP problem after upgrading to 4.2.112

I just upgraded a WLC from 4.1.185 to 4.2.112. Now none of my H-REAP AP's will connect to the WLC. It appears that they connected long enough to upgrade their code, but never reappear after the reboot. The AP ports are trunked and VLAN tagging is enabled on the WLC H-REAP AP Config. Did anything change from 4.1.185 to 4.2.112?

1 REPLY
New Member

Re: H-REAP problem after upgrading to 4.2.112

Update - After 4 hours 45 minutes the H-REAP AP's joined the WLC and stayed connected. I rebooted one to see what would happen and after an hour it's still bouncing on the WLC. Very strange that AP's in local mode are fine.

110
Views
0
Helpful
1
Replies