Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

help aironet 1240 ag

hello

I have to create a ssid and configure security with encryption and password wap ascii "log2011mfe"

I set it up via telnet command with the deputy and all is well finished with crltZ and all is well, but when the web server aironet, tells me that the wireless is down, that there is no ssid configured

1240AG> enable

1240AG# configure terminal

1240AG (config)# interface dot11radio 0

1240AG (config-if)# encryption vlan 40 mode ciphers tkip

1240AG (config-if)# ssid Guest

1240AG (config-if-ssid)# vlan 40

1240AG (config-if-ssid)# authentication open

1240AG (config-if-ssid)# authentication key-management wpa

1240AG (config-if-ssid)# wpa-psk ascii log2011mfe

Product/Model Number: AIR-AP1242AG-E-K9

  System Software Filename: c1240-k9w7-tar.123-8.JA2

  System Software Version: 12.3(8)JA2

  Bootloader Version: 12.3(7)JA1

  System Uptime: 55 minutes

6 REPLIES

Re: help aironet 1240 ag

After you do the config in the cli you need to do a wr mem.

Steve

Sent from Cisco Technical Support iPad App

HTH, Steve ------------------------------------------------------------------------------------------------ Please remember to rate useful posts, and mark questions as answered
New Member

help aironet 1240 ag

hello

thanks for your quick response

but do not understand I'm a newbie

I have to reboot?

I do not understand this: need to do a wr mem

Hall of Fame Super Gold

help aironet 1240 ag

What Steve meant was this:

AP# wr

Re: help aironet 1240 ag

Hi Luis and welcome to CSC.

What Steve and Leo are mentoning about the "wr mem" is to SAVE your config after you have configured your access point. Have you done that ?

__________________________________________________________________________________________ "Satisfaction does not come from knowing the solution, it comes from knowing why." - Rosalind Franklin ___________________________________________________________

Re: help aironet 1240 ag

Luis:

My colleagues metnioned you should save the config but I think it should work without saveing the config. if config not saved then you will lose hte configuraiton after restart. However, after configuation and before save the configuraiton should be applied.

What do you think guys?

Make sure that your radio interface is not shutdown.

(show ip int brief) command will show you what interfaces are up and what are down.

but before that, have you configured the SSID?
this is configured before configuring the interface:

(dot11 ssid Guest).

It was long time since I dealt with autonomous. But I am sure that dot11 SSIDs are configured separately (not inside the interface) with their authentication mechanism. Then After doing that you add the SSID under the interface (ssid Guest).

Try it this way.

Good luck.

Amjad

Rating useful replies is more useful than saying "Thank you"

Re: help aironet 1240 ag

One more thing came to my mind:

you need to enable broadcast for the SSID with the command "guest-mode".

are you doing this in your configuration?

Rating useful replies is more useful than saying "Thank you"
332
Views
0
Helpful
6
Replies
CreatePlease login to create content