i've just upgraded our WLSE to WCS using CDs 80-8572-01 and 80-8568-01 following the Cisco documentation. the upgrade seemed to have gone well but i can't login throu the WCS web gui. i get the error:-
Error(s): You must correct the following error(s) before proceeding:
Login Failed. Please try again with valid username and password.
i've enabled remote access on the WCS and i can SSH to it no problem but can't use the same root/password through the GUI. Do i have to enable this on the WCS? my linux skills are pretty poor - any help appreciated.
I had a similar problem - I tried logging in between disc 1 and disc 2 as I got stuck on the upgrade (disc 2 was faulty, but that's another story) the default login worked ok. When I eventually got a replacement disc 2 and completed the upgrade I couldn't log in and wondered if I'd somehow accidentally changed the password. After half an hour of trying a variety of passwords I decided to reload from the Linux CLI and once it rebooted I got into the GUI on the first try with the default username and password.
Yes the console login (Linux) is a different one to the GUI as you're logging into WCS there instead - was there a prompt during the conversion process to enter a password for the root user of WCS? Try that one instead.
Transferring Crash file from standby:
Login to the Active WLC in HA.
(Cisco Controller) >transfer upload datatype crash
(Cisco Controller) >transfer upload filename <Desired filename>
(Cisco Controller) >transfer up...
This is the start of a display filter cross reference between Wireshark and OmniPeek.
The 1st installment is a table of advanced filters. More filters will be added as time allows.
It is a living doc, so check back for changes every so often
Please feel ...
I have created a Powershell script to automatically add a Wireless Guest User on Cisco WLCs. (tested on 2500 Series)
The script should be completely self explanatory.
Powershell SNMP Module (Install-Module -Name SNMP)
SNMP Write Access to...