Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Help wlse wnm status authenticated but not security keys setup

Hi all, i have a WLSE 2.15.2 and AP 1100 12.3(JEB), the state of the AP NM status is authenticated instead of security keys setup, they know because can be?, by this razon apparently does not send the AP the messages of RM to the WLSE, thanks.

  • Security and Network Management
3 REPLIES
Silver

Re: Help wlse wnm status authenticated but not security keys set

Can you try to Enable *all* radio interfaces so that they're "up" in the "show ip interfaces brief" and then redo the inventory on the WLSE. Leave them up until the wlccp link comes to "SECURITY_KEYS_SETUP". Once it comes to that state, you can shut down the radio interface.Even after a reload, the SECURITY_KEYS_SETUP will remain.To expedite the process, run a Discovery job on the AP.

New Member

Re: Help wlse wnm status authenticated but not security keys set

Hi,

here is a link to a reported bug in ACS 3.3.3. Check if that applies to your case.

http://tools.cisco.com/Support/BugToolKit/search/getBugDetails.do?method=fetchBugDetails&bugId=CSCsb47726

Regards,

V

New Member

Re: Help wlse wnm status authenticated but not security keys set

Thank you so much for its aid, finally carry out upgrade of ACS 3.3.3 to 4,0 since find not just then this BUG. Greetings.

240
Views
0
Helpful
3
Replies
This widget could not be displayed.