I try to configure AP340 Series for hot standby mode. I have configure "Select "NO" for the Adopt Primary Port Identity option in the AP Radio row under Network Ports. When i try to start hot standby mode after i keyin the MAC address of AP to be monitor, the standby AP show this "Lost authentication from parent" for few times (view from hyper terminal). But the standby AP still associated to parent AP. The standby AP's STATUS LED will keep flashing.
May i know what is the authentication needed to associate with monitored AP ? Why my standby AP will not automatically roam back all users to monitored AP after replacing the monitored AP back online ?
Transferring Crash file from standby: Login to the Active WLC in HA.
From CLI: (Cisco Controller) >transfer upload datatype crash (Cisco
Controller) >transfer upload filename (Cisco
Controller) >transfer upload mode tftp (Cisco Controller) >transfer
This is the start of a display filter cross reference between Wireshark
and OmniPeek. The 1st installment is a table of advanced filters. More
filters will be added as time allows. It is a living doc, so check back
for changes every so often Please feel f...