How can I revert back to the default config on Secure Access Server 5.3?
We recently purchased new Secure Access Control Servers version 5.1 and have upgraded to version 5.3 with current patches. Several people have configured one of the appliances and we would like to revert back to the original config with no NDGs or Devices or any other variables configured. Is this possible?
How can I revert back to the default config on Secure Access Ser
While looking up a command in the CLI reference, I also found the command to reset the acs to factory default. It is "acs reset-config". This resets the acs portion only, not the linux appliance, so your IP addresses, DNS, etc. are retained. It does clear out the license for the ACS, so if you use this make sure you have the license file. You will also have to go through the initial password setup again.
Transferring Crash file from standby:
Login to the Active WLC in HA.
(Cisco Controller) >transfer upload datatype crash
(Cisco Controller) >transfer upload filename <Desired filename>
(Cisco Controller) >transfer up...
This is the start of a display filter cross reference between Wireshark and OmniPeek.
The 1st installment is a table of advanced filters. More filters will be added as time allows.
It is a living doc, so check back for changes every so often
Please feel ...
I have created a Powershell script to automatically add a Wireless Guest User on Cisco WLCs. (tested on 2500 Series)
The script should be completely self explanatory.
Powershell SNMP Module (Install-Module -Name SNMP)
SNMP Write Access to...