How do I get syslog messages from an AP350 sent to my Ciscoworks2000?
I am running Ciscoworks2000 and trying to get my Access Point's to send messages to the RME. I have enabled SNMP and created user's with the correct SNMP strings? Any help in getting as much information from the AP's to Ciscoworks would be greatly appreciated.
Re: How do I get syslog messages from an AP350 sent to my Ciscow
I am running Ciscoworks Common Services 2.2 and RME 3.5 I downloaded the newest bundle of devices. I can see the Access Point as a device. I just need to see messages from it. Do you have one that is working?
In particular, please make sure that you check the 'Yes' button for 'Should Syslog Messages use the Cisco EMBLEM Format', otherwise RME will not recognise the format of the syslog messages that it receives.
As mentioned by one of the other respondants, you must also check that the AP is recognised in the RME Inventory as a Managed Device.
Transferring Crash file from standby:
Login to the Active WLC in HA.
(Cisco Controller) >transfer upload datatype crash
(Cisco Controller) >transfer upload filename <Desired filename>
(Cisco Controller) >transfer up...
This is the start of a display filter cross reference between Wireshark and OmniPeek.
The 1st installment is a table of advanced filters. More filters will be added as time allows.
It is a living doc, so check back for changes every so often
Please feel ...
I have created a Powershell script to automatically add a Wireless Guest User on Cisco WLCs. (tested on 2500 Series)
The script should be completely self explanatory.
Powershell SNMP Module (Install-Module -Name SNMP)
SNMP Write Access to...