how to get online help when creat new filter files in EDS?
I want to creat some my own filter files in order to get Event report from network management station when some special situations appear.
I have run /opt/CSCOpx/bineds -filter,and the Named Filter window appears,I select new a file,later select "add Generic events",during this course I tried to get online help with Help Icon, but the messages:"could not run netscape to display help netscape:not found."appears.
But I have install the netscape in the directory /opt/netscape, why it can't be found?I want to know whether there is some conf file in some place that has named a path name for the netscape diffrent from /opt/netscape.Is ther any such files?Thanks very much!
Re: how to get online help when creat new filter files in EDS?
Since there has been no response to your post, it appears to be either too complex or too rare an issue for other forum members to assist you. If you don't get a suitable response to your post, you may wish to review our resources at the online Technical Assistance Center (http://www.cisco.com/tac) or speak with a TAC engineer. You can open a TAC case online at http://www.cisco.com/tac/caseopen
If anyone else in the forum has some advice, please reply to this thread.
Transferring Crash file from standby: Login to the Active WLC in HA.
From CLI: (Cisco Controller) >transfer upload datatype crash (Cisco
Controller) >transfer upload filename (Cisco
Controller) >transfer upload mode tftp (Cisco Controller) >transfer
This is the start of a display filter cross reference between Wireshark
and OmniPeek. The 1st installment is a table of advanced filters. More
filters will be added as time allows. It is a living doc, so check back
for changes every so often Please feel f...
I have created a Powershell script to automatically add a Wireless Guest
User on Cisco WLCs. (tested on 2500 Series) The script should be
completely self explanatory. Prerequisites: Powershell SNMP Module
(Install-Module -Name SNMP) SNMP Write Access to y...